Flortex EP XFH

With all the benefits of Flortex EP, we have incorporated extra fast hardeners into the formulation, enabling the resins to cure quicker and harder.
This solvent free twin pack epoxy is incredibly strong and is excellent for heavily trafficked floors needing a rapid return to work.
Fast curing in only 8-10 hours @ 20oC reduces down time and aggravation by at least 50%

Supplied in 5kg units (smooth) or 7kg (slip resistant)

Number of parts:2
Pot Life @ 20oC:15 minutes
Application Temperature:15oC to 25oC
Initial Cure:8 – 10 hours
Coverage:15 – 20m²

Please consult the technical data sheet for full technical product data.

Preparation:Thorough substrate preparation is essential.Recommended methods are:
Powerfloated concrete – use a Vacuum Assisted Shotblaster to remove weak laitence and provide a surface key for the coating. If this is not possible, chemically etch with Polycote Etch IT then rinse thoroughly and allow to dry.
Loose paint or rust – remove, using a Vacuum Assisted Shotblaster, Floor Grinder or equivalent method.
Loose or friable concrete – use a Vacuum Assisted Shotblaster. If this is not possible, chemically clean with Polycoate Etch IT then rinse thoroughly and allow to dry.
Oil or grease – use Hot Compressed Air for large areas of contamination. Smaller, isolated deposits may be chemically cleaned with Polycote Degrease IT, then rinsed thoroughly and allowed to dry.
Prior to application of Flortex EP XFH, a suitable primer should be applied.
These include Polycote EP Primer, WD Primer or OT Primer, depending on the type and condition of the surface.
Please contact Polycote Technical Helpline, and prepare the surface in accordance with the appropriate primer data sheet.
Mixing:
Having fully prepared the substrate, stir the individual components before mixing together. Add Part ‘B’ to Part ‘A’ and thoroughly mix for at least 3 minutes.
For best results use a heavy duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation. However, do not overmix as this will reduce working time with the product.
Application:
Apply by brush, roller or squeegee, making sure that the surface is completely covered.
Particular attention should be given to doorways and other areas of high traffic. When finished, DO NOT scrape the remaining contents from the container as this will invariably include unmixed resin.