PB Non Slip Floor Paint

Formulated from the latest resin technology, PB Floor Paint is incredibly tough and long lasting with good oil and chemical resistance.

Use on: Concrete. For other substances contact Polycote Experts.
Use where:Internal
Typical industries: Widely used throughout industry. Warehouses, factories, showrooms, workshops, hotels, farms and garages have all proved the superb qualities of PB Floor Paint.

Special features: Tough but flexible, chemical resistant, impact resistant, abrasion resistant, quick and easy to apply, can be applied over previously painted surfaces, fast curing, superb adhesion qualities, very high opacity/solids content

Application temperature:5oC – 30oC
Touch dry time:3 hours @ 20oC
Hard dry time:5 hours
Number of parts supplied:1
Coverage:5L unit – 30m 2
Priming required:No

Please consult the technical data sheet for full technical product data.

Preparation:Thorough substrate preparation is essential.The surface must be clean, dry and free from dirt, grease and other contamination. New concrete should be left for at least 3 months before painting, and a moisture check should be carried out to ensure this lies within acceptable limits. Hard concrete or granolithic surfaces should be treated with Polycote Etch IT to improve adhesion, and any surface grease or contamination chemically removed using Polycote Degrease IT. These treatments must be thoroughly rinsed off and the surface allowed to dry before painting. Pits and holes may be filled using Polycote Cretex products. Please refer to relevant Data Sheets.
Mixing:
Stir very thoroughly before use to ensure full dispersion of solids throughout the mix. Mechanical mixing is advised.
Application:
Apply by roller or brush. If the area has not previously been treated, thin the first coat with 10% White Spirit to improve penetration and adhesion working well into the surface. Apply full second coat. On previously sealed floors apply two coats. On previously painted surfaces one coat may provide adequate coverage.Avoid applying too thickly. Do not cover at a rate less than 30m² per 5L unit. Applying polyurethane paint too thickly can prevent curing.