Ensure the floor is clean and all weak or loose paints or screeds are removed.
Once cleared, carry out the final surface preparation using: Etch IT – for a clean, unpainted surface. Degrease IT – for floors with oil and grease contamination. Mechanical preparation – is necessary if you need to remove old coatings screeds or if you are wanting to smooth out the surface.
Ensure your application tools are unwrapped, made up and ready to use.
Mixing
Having fully prepared the substrate, add all the contents of the curing agent – Part B to the epoxy resin – Part A.
Mix thoroughly for several minutes using a low-speed electric drill until a clear homogenous mix is obtained
Keep all components at room temperature for at least 24 hours before use.
Application
The material should be poured into the crack immediately after mixing using a jug or suitable pouring vessel.
A bead of caulk/ sealant may be applied temporarily along each side of the crack to prevent the flow of the material onto the surrounding area.
Surplus mixed material may generate considerable heat within the container at the end of the pot life.
Any unused material is best mixed with sand to reduce heat output before leaving to cure off and then discarding.
Account
